Description
Hello! I present you a new measuring tool for M1-M10 bolts, nuts, screws with some special considerations!
You can also measure the pitch / thread of a given screw / bolt if you print it very fine.
 

 
I had another gauge but it was a remix and I did not like some of the base model features so I made this one from scratch.
 
Features:
bolt/screw/nut sizes: M1 M1.2 M1.6 M2 M3 M4 M5 M6 M8 M10
lengths from 1-120mm
pitch/thread sizes: 0.2 0.25 0.3 0.35 0.4 0.45 0.5 0.6 0.7 0.75 0.8 1 1.25 1.5 1.75 2
big numbers for easy reading
contrasting colors for the letters and the measure lines - only 2 filament swaps!
nut gauge has inner studs for precise inner M measurement (there are M nuts with a non-standard outer size)
nut gauge can measure other M hardware with M threads
10mm hole for easy wall storage
2x3 gridfinity grid for easy gridfinity storage
magnet holes for 6x2mm magnets (you need glue)

 
You can print the tool with a 0.4mm nozzle but then some of the fine threads are lost. I recommend 0.2mm if you want the fine lines.
 
Print settings - high quality, fine threads - time 12:56h
0.2mm nozzle
0.06mm adaptive layer (0.5 ratio)
6 walls
seam position back
ironing top surfaces
arachne walls (important)
5% adaptive cubic infill
no brim
no prime tower (not needed, less waste, faster print)
 
Print settings - medium quality, pitch 0.5-2 - time 4h
0.4mm nozzle
0.08mm adaptive layer (0.5 ratio)
3 walls
everything else like above (!)
 
Print settings - medium quality, pitch 1.25-2 - time 2:40h
0.4mm nozzle
0.2mm adaptive layer (0.5 ratio)
3 walls
everything else like above
 
Print settings - low quality, pitch 1.5-2 - time 1:40h
0.4mm nozzle
0.28 adaptive layer (0.5 ratio)
2 walls
no ironing
everything else like above
 
https://makerworld.com/en/models/894027-screw-bolt-nut-pitch-thread-measuring-tool-m1-m10?from=search#profileId-851434