https://makerworld.com/en/models/1620135-drill-bit-holder-metric-and-imperial-ikea-skadis?from=search#profileId-1710122

Drill Bit Holder 1-13 mm or 1/16-½ inch for an Ikea Skadis pegboard.

 

Update! By popular demand, I have added new print profiles for imperial drill bits (imperial version).

 

The holder accommodates a total of 25 drill bits from 1 - 13mm (in 0.5mm increments) or 29 drill bits from 1/16 - ½ inch (in 1/64 inch increments).

 

There are four different versions, two where the shank diameter of the drill bits is a maximum of 10mm (or 3/8 inch for the imperial version), meaning drill bits over 10mm (3/8 inch) drilling diameter have a reduced shank of 10mm (3/8 inch). The other two versions are for drill bit sets where the shank always matches the drilling diameter, meaning it also goes up to 13mm (or ½ inch).

Of these two variants, there is an AMS version (the numbers are printed in a different color) and a NonAMS version (the numbers are designed as an indentation in the holder).

Please check before printing which version is suitable for your drill bit set. Bosch drill bits, for example, usually have a shank reduced to 10mm.

 

On a pegboard, several holders can be arranged directly next to each other or with a slight distance above one another.

For easy removal and to optimize space on the pegboard, the receptacles are arranged at a 45-degree angle. In addition, there is a small storage compartment at the back of the holder to make practical use of the necessary clearance.

 

The model can be printed with various materials; minimal support is necessary.

Especially with the AMS version, good bed adhesion should be ensured so that the numbers do not detach on the first layers; an increase in bed temperature by 5-10 degrees can be helpful.